freemanc2r

Pour tout ceux qui sont passer en 6.20 voici une astuce sur laquelle je suis tomber sur le forum de la tx : 

Although the following method may not allow you to boot into the "Custom FW" this method will allow you to boot back into your Original FW. 

Do the following:

1.Press the (-) and Power button while the Xecuter tool is plugged , in order to boot into the Team Xe-cuter menu. Once there, make sure the Auto RCM is turned off.
2.Than go back to the main menu and select Boot Original FW.
3. Now Press and hold the (-) and (+) buttons, while holding these, press the power button once, until the NINTENDO logo comes up. This should reset your NINTENDO SWITCH and you will have access to your Original FW.

Good luck!!!!

Cela permet de remetre la console a son etat de depart apparament mais je peux pas tester car j'ai pas fais la mise a jour

Pour tout ceux qui sont passer en 6.20 voici une astuce sur laquelle je suis tomber sur le forum de la tx : 

Although the following method may not allow you to boot into the "Custom FW" this method will allow you to boot back into your Original FW. 

Do the following:

1.Press the (-) and Power button while the Xecuter tool is plugged , in order to boot into the Team Xe-cuter menu. Once there, make sure the Auto RCM is turned off.
2.Than go back to the main menu and select Boot Original FW.
3. Now Press and hold the (-) and (+) buttons, while holding these, press the power button once, until the NINTENDO logo comes up. This should reset your NINTENDO SWITCH and you will have access to your Original FW.

Good luck!!!!

Cela permet de remetre la console a son etat de depart apparament mais je peux pas tester car j'ai pas fais la mise a jour

Pour tout ceux qui sont passer en 6.20 voici une astuce sur laquelle je suis tomber sur le forum de la tx :

Although the following method may not allow you to boot into the "Custom FW" this method will allow you to boot back into your Original FW.

Do the following:

1.Press the (-) and Power button while the Xecuter tool is plugged , in order to boot into the Team Xe-cuter menu. Once there, make sure the Auto RCM is turned off.
2.Than go back to the main menu and select Boot Original FW.
3. Now Press and hold the (-) and (+) buttons, while holding these, press the power button once, until the NINTENDO logo comes up. This should reset your NINTENDO SWITCH and you will have access to your Original FW.

Good luck!!!!

Cela permet de remetre la console a son etat de depart apparament mais je peux pas tester car j'ai pas fais la mise a jour